Had to restart the route after 1 mile. Start in Dundee. Evidently, this was the chip-seal ride. The first chip-seal section, 2 miles, was Dayton Ave, just 2 miles into the ride. NE Tangen Rd, mile 5, was recently re-paved. Nice, smooth surface. However, that didn't last long. The next chip-seal section, almost 4 miles, was on North Valley Rd. This was worse than the Dayton Ave. stretch, with more loose gravel and a pilot car guiding traffic. Fortunately, after 2 miles was able to get into the right-hand lane, where there was no loose gravel. Road conditions back to normal at the North Valley Rd and Ribbon Ridge Rd intersection. Nice spin to Laughlin Rd. Slight crosswind/headwind on Laughlin Rd, which isn't typical. First stop, mile 20.5, at Yamhill-Carlton school. Several rollers on Moores Valley Rd and Westside Rd. More chip-seal on Meadow Lake Rd into Carlton. More crosswind/headwind on Mineral Springs Rd, just before Lafayette. Enjoyed some tailwind from Lafayette to the dreaded Worden Hill. This is a fairly tough 1.8 mile climb with 700 feet elevation gain. There are three distinct steep pitches, 11-14% grade. The 1.5 mile descent is fantastic, but is followed by a 0.4 mile steep hill, then another 1.2 mile descent into Dundee.