Night Rider had another rough start Garmin wouldn't connect to bike sensors,after a bit realized the bike profile was rest to wrong bike... then it wouldn't connect to speed/cadence, needed to replace battery after all that the rear tire went flat put another tube it and it went flat checked tire for something causuing flats didn't find anything put another tube in and was good to go. started the ride 1.5 miles into the ride I noticed the iBike computer wasn't recording, for some reason it didn't lock on to any of the sensors so I had to check to make sure it was set the correct bike, it was so I re-initialize the system, now it picked p all sensors ans was workng. The night was not severely cold but cold all the same, damp air and a srong breeze. I decided to do a ride I hadn't done in a lon while, I wanted to see how much of the road I was on last week was oaved... on my way to the destination road Rte 539 from Plumstead Rte 532 I hit a lot of dense fog not as bad as last night and was on and off for abot 7 miles.the areas of 532 that was all dugged up was repaved and was nicely done.except for 150 yards before traffic light to Rte 539 and for about 1/2 mile it was all bumpy and rough road. I should have turn right on the street just beore traffic light, that road was a newly pave and very nice road which goes into 539 just past all the really bad section! %39 was not repaved it was only repaved in sections that really bad but the it was very ridable with a few spots that were a little rough. I ttok 539 all the way to Rte 70 and the newly paved section of 539 was just before where I got on it last week, LOL! Going back home on Rte 70 I kept my eys open for the tree branches on the shoulder, it was must have been removed because it was gone! All in all this was a very nice ride, I will be doing it with a few small changes as part of my regular routes.